31
2.3 Overview
With the CPU iC9226M-EC electronics and power supply are integrated in one housing. The CPU is programmed and
configured with iCube Engineer from Yaskawa in IEC 61131-3. On the right side via the SliceBus you can connect
System SLIO periphery modules from Yaskawa. As head module via the integrated power module for power supply
CPU electronic as well as the electronic of the periphery modules, which are connected via the SliceBus. For the
connection of the power supply the CPU has a removable connector. To supply the power section of the connected
periphery modules, you must always plug in the power module 007-1AB00 - DC 24V 10A directly after the CPU.
(2)
Power Modules
When using System SLIO modules, you must always mount the power module 007-1AB00 - DC 24V 10A, because the CPU
does not provide a power section supply due to the system.
The color-coded power modules are used when the CPU does not provide power section supply, like the CPU
iC9226M-EC. These are also to be used if the power section supply of the I/O level or the electronic power supply is
no longer sufficient. Depending on the power module used, you have the option of forming isolated groups.
The power modules are to be supplied externally with DC 24V. Each power module has over voltage and reverse
polarity protection.
(3)
Periphery Modules
The periphery modules are available in the following versions, whereby of each the electronic part can be replaced with
standing wiring:
• 8x periphery modules for a maximum of 8 channels.
– Standard periphery modules
• 16x periphery module for a maximum of 16 channels.
2
Overview
To Next Page
Loading...
