57
3.3 Wiring the iC9200
(4) Wiring Power Modules
(a) Terminal Module Terminals
Power modules can be plugged between the periphery modules. With power modules, terminals with spring
clamp technology are used for wiring. The spring clamp technology allows quick and easy connection of your
signal and supply lines. In contrast to screw terminal connections this type of connection is vibration proof.
(b) Data
U
max
30V DC
I
max
10A
Cross section 0.08 ... 1.5mm
2
(AWG 28 ... 16)
Stripping length 10mm
(c) Wiring Procedure
1 Pin number at the connector
2 Opening for screwdriver
3 Connection hole for wire
1. Insert a suited screwdriver at an angel into the square opening as shown. Press and
hold the screwdriver in the opposite direction to open the contact spring.
2. Insert the stripped end of wire into the round opening. You can use wires with a cross
section of 0.08mm
2
up to 1.5mm
2
3. By removing the screwdriver, the wire is securely fixed via the spring contact to the
terminal.
3
Installation and Wiring
To Next Page
Loading...
