87
4.8 Web-Based Management - WBM
You can remove entries with and edit them with .
4. Click on [Apply].
You will receive a message that applying the new NTP daemon configuration requires a restart
of the NTP daemon and that this may lead to a real-time violation. With [OK], the NTP servers
listed in the table are accepted for time-of-day synchronization and the NTP daemon is restarted.
(3) System Services
Here you can find status information about the enabled and disabled system services, as well as their
factory default settings. You can increase the efficiency of your system by deactivating services that are
not required.
• Before disabling a service that is enabled by default, make sure that it is also not required for the entire system.
• Please also note that changing a setting always overwrites the entire system services settings.
• When PROFINET (optional) is disabled, the DCP protocol, which is used for identification and IP address
assignment
for participants in the PROFINET network, is also disabled.
1. Enable/Disable System Service
1. By selecting or deselecting the corresponding check box, you enable
respectively disable a system service in the list.
2. Use the [Apply and Reboot] button to apply the settings for the system services.
After a security query, the settings for the system services are adopted and the CPU is restarted.
4
Deployment
To Next Page
Loading...
