106
4.8 Web-Based Management - WBM
3. Starting an App
To start an app, click in the table [Installed iCube Apps] at [Start] behind the corresponding
app.
The app is started and the app status [RUN] in the column [App Status] is shown.
Please note that starting multiple apps may require a CPU restart. You will be informed of the impending restart by
a dialog that opens.
4. Quit an App
To quit an app, click in the table [Installed iCube Apps] at [Stop] behind the corresponding
app.
The app is quit and the app status [Stop] in the column [App Status] is shown.
5. Uninstalling an App
1. To uninstall an app, you must quit it first. To do this, click in the table [Installed iCube
Apps] at [Stop] behind the corresponding app.
2. To uninstall, click the following in the table [Installed iCube Apps] at [Uninstall] behind
the corresponding app.
After a security prompt, the corresponding app is uninstalled.
(2) Firmware Update
Here you can execute a firmware update on your CPU.
Please note that you can only execute a firmware update with administrator rights!
1. Proceeding
You can find the currently installed firmware version of your CPU in the WBM at [Information] - [General
Data]. Here you can also check whether the firmware update was successful.4.8.2(1) General Data on page 74
1. The latest firmware can be found at
https://www.icubecontrol.com/downloads.html
Load the current firmware file into your working directory.
CAUTION
When installing a new firmware you have to be extremely careful. Under certain circumstan-
ces you may destroy the CPU, for example if the voltage supply is interrupted during trans-
fer or if the firmware file is defective. In this case, contact our support!
To Next Page
Loading...
