35
2.3 Overview
(c) Coding Pins
Please note that a coding pin cannot be installed on a 16x periphery module! Here you have to make sure that the associ-
ated terminal block is plugged again when the electronics unit is replaced.
There is the possibility to fix the assignment of electronic and terminal module. Here coding pins (order number
000-0AC00) from Yaskawa can be used. The coding pin consists of a coding jack and a coding plug. By combin-
ing electronic and terminal module with coding pin, the coding jack remains in the electronic module and the
coding plug in the terminal module. This ensures that after replacing the electronic module just another electronic
module can be plugged with the same encoding.
2.3.3 Hardware Revision
• The hardware revision is printed on every module.
• Since a System SLIO 8x periphery module consists of a terminal and electronic module, you will find a hard-
ware revision printed on each of them.
• The hardware revision of the iC9226M-EC is indicated on the left side nameplate.
• Authoritative for the hardware revision of a System SLIO module is the hardware revision of the electronic
module. This is always located under the labeling strip of the corresponding electronic module.
• Depending on the module type, there are the following 2 variants e.g. to indicate hardware revision 1:
– With current labelling there is a on the front.
– With earlier labelling, the 1 is marked with [X] on a number grid.
1
2
Overview
To Next Page
Loading...
