47
3.3 Wiring the iC9200
This chapter describes wiring the iC9200 to various devices.
3.3.1 Wiring the Power Supply
Use a 24-VDC power supply to supply power to the power connector on the iC9200 (model number: JEYRM-
MPX022□□10L32-□).
This section describes the specifications, pin assignments, and connection method for the power connector.
Name
Connectors
No. of
Pins
Connector Model No.
Unit Side Cable Side Manufacturer
Power Connector X2 3 4-2013519-3 4-2013522-3 TE Connectivity Ltd.
Note:
Use an isolated 24-VDC power supply and install the power switch on the AC side.
If you install the power switch on the 24-VDC side, inrush current of approximately 40 A will flow when the power is turned ON.
(1) Creating the 24-VDC Power Cable
The power terminal is a removable connector. Use the following procedure to wire the power connector. When
connecting the power connector on the iC9200 to a 24-VDC power supply, use twisted-pair wires with a wire
size between AWG20 and AWG14 (0.5 mm
2
and 2.0 mm
2
).
Use the following procedure to create the power cable.
3.3 Wirin
the iC9200
Input power within the rated voltage over the wiring to the iC9200.
Pin No. Signal Label Description
3 DC24V 24-VDC input
2 DC0V 0-VDC input
1
FG
Connect to the frame ground.
3
Installation and Wiring
To Next Page
Loading...
