56
3.3 Wiring the iC9200
(b) Data
U
max
30V DC
I
max
10A
Cross section solid wire 0.25 ... 0.75mm
2
Cross section with ferrule 0.14 ... 0.75mm
2
Wire type CU
AWG 24 ... 16
Stripping length 10mm
(c) Wiring Procedure
1
2
1 Release area
2 Connection hole for wire
Insert Wire
The wiring happens without a tool.
1. Determine according to the casing labelling the connection position.
2. Insert through the round connection hole of the according contact your prepared wire
until it stops, so that it is fixed.
By pushing the contact spring opens, thus ensuring the necessary contact pressure.
Remove Wire
The wire is to be removed by means of a screwdriver with 2.5mm blade width.
1. Press with your screwdriver vertically at the release button.
The contact spring releases the wire.
2. Pull the wire from the round hole.
To Next Page
Loading...
