58
3.3 Wiring the iC9200
(d) Deployment of the Power Modules
• The CPU does not provide a power section supply for the periphery modules. By plugging the power module
with the order no. 007-1AB00 the succeeding periphery modules get a DC 24V power section supply with
max. 10A. If the 10A are no longer sufficient, another power module must be plugged. So you have also the
possibility to define isolated groups.
• The periphery modules get their electronic power supply from the CPU with max. 3A. The power module
with the order number 007-1AB10 is to be used if the 3A for the electronic power supply at the backplane bus
is no longer sufficient. Additionally you get a new isolated group for the DC 24V power section supply with
max. 4A.
• By plugging the power module 007-1AB10, modules with a maximum total current of the power section sup-
ply of 2A can be plugged at the succeeding backplane bus. Afterwards a power module is to be placed again.
To secure the power supply, the power modules may be mixed used.
(e) Power Module 007-1AB00
(1) DC 24V supply CPU:
DC 5V electronic section supply I/O area (max. 2A)
(2) Power module 007-1AB00:
DC 24V power section supply (max. 10A)
(f) Power Module 007-1AB10
(1) DC 24V supply CPU:
DC 5V electronic section supply I/O area (max. 2A)
(2) Power module 007-1AB00:
DC 24V power section supply (max. 10A)
(3) Additional power module 007-1AB10:
(4) DC 24V power section supply (max. 4A)
(5) DC 5V electronic section supply I/O area (max. 2A)
To Next Page
Loading...
