1.12 U: Monitor Parameters
256 YASKAWA ELECTRIC SIEP C710606 10A YASKAWA AC Drive - V1000 PRELIM. Programming Manual
Refer to page 369 for a complete list of U4- monitors and descriptions.
◆ U5: PID Monitors
These monitors display various aspects of PID control. Also refer to the PID Block Diagram
on page 63 for a description of where each monitor is located in the PID control block.
Refer to page 373 for a complete list of U5- monitors and descriptions.
◆ U6: Control Monitors
Control monitors show:
• Reference data for the output voltage and vector control.
• ASR monitors. Refer also to C5: Automatic Speed Regulator (ASR) on page 86 for
details and an illustration that shows where in the ASR block the monitors are located.
• The offset value added to the frequency reference by the Frequency Offset function. Refer
to Setting 44/45/46: Offset Frequency 1/2/3 Addition on page 152.
• The bias value added to the frequency reference by the Up/Down 2 function. Refer to
Setting 75/76: Up/Down 2 on page 154.
Refer to page 373 for a complete list of U6- monitors and descriptions.
◆ U8: FBD’s Monitors
These monitors are reserved for use with FBD’s.
Refer to page 373 for a complete list of U8- monitors and descriptions.
To Next Page
Loading...
