YASKAWA OYMC V1000

1.11 Auto-Tuning
YASKAWA ELECTRIC SIEP C710606 10A YASKAWA AC Drive - V1000 PRELIM. Programming Manual 247
Parameter Details
1
4. Enter the motor nameplate data.
5. Start the Auto-Tuning process when prompted by the drive.
6. If Auto-Tuning was successfully performed, do a test run without the load and make any
necessary parameter adjustments.
7. If the test run was successful, do a test run with the load connected and make parameter
adjustments if necessary.
◆ Auto-Tuning Example
The following example illustrates how to perform Rotational Auto-Tuning for Open Loop
Vector Control (A1-02 = 2).
■ Set the Selected Type of Auto-Tuning
■ Enter Data from the Motor Nameplate
After selecting the type of Auto-Tuning, enter the data required from the motor nameplate.
Note: These instructions continue from Step 8 in “Selecting the Type of Auto-Tuning”.
Step Display/Result
1. Turn on the power to the drive. The initial display appears. ⇒
2.
Press the key until the Auto-Tuning display appears.
⇒
3.
Press to begin setting parameters.
⇒
4.
Press to display the value for T1-01.
⇒
5.
Press to select the digit to edit.
⇒
6.
Press and set the drive to perform Rotational Auto-Tuning
(00).
⇒
7.
Save the setting by pressing .
⇒
8. The display automatically returns to the display shown in Step 3. ⇒