A.2 Parameter Table
298 YASKAWA ELECTRIC SIEP C710606 10A YASKAWA AC Drive - V1000 PRELIM. Programming Manual
◆ b: Application
Application parameters configure the Run Command Source, DC Injection Braking, Speed
Search, Timer functions, PID control, the Dwell function, Energy Savings and a variety of
other application-related settings.
A1-06 Application Preset
Sets parameters that are commonly used in certain
applications to A2-01 through A2-16 for easier
access.
0: General-purpose (A2 parameters are not affected)
1: Water supply pump
2: Conveyor
3: Exhaust fan
4: HVAC fan
5: Air compressor
6: Hoist
7: Travelling
0 to 7 0 A A A 127 25
A1-07
FBD’s Function
Selection
0: Disabled
1: Enabled
2: Multi-function input (enabled when H1- =
9F)
0 to 2 0 A A A 128 33
A2: User Parameters
Use A2 parameters to program the drive.
A2-01
to
A2-32
User Parameters,
1 to 32
Parameters that were recently edited are listed here.
The user can also select parameters to appear here
for quick access.
Parameters will be stored here for quick access
when A1-01 = 1.
b1-01 to
o2-08
--
<16>
AAA
106 to
125
33
A2-33
User Parameter
Automatic
Selection
0: Parameters A2-01 through A2-32 are reserved for
the user to create a list of User Parameters.
1: Save history of recently viewed parameters.
Recently edited parameters will be saved to A2-17
through A2-32 for quick access.
0,1
1
<4>
A A A 126 34
<4> Default setting value is dependent on parameter A1-06. This setting value is 0 when A1-06 = 0, and 1 when A1-06
does not = 0.
<16> Default setting value is dependent on parameter A1-06, Application Selection.
<22> Parameter can be changed during run.
No. Name Description Range Def.
Control
Mode
Addr.
Hex
Pg.
V/f
O
LV
P
M
To Next Page
Loading...
