YASKAWA OYMC V1000

A.2 Parameter Table
YASKAWA ELECTRIC SIEP C710606 10A YASKAWA AC Drive - V1000 PRELIM. Programming Manual 357
Parameter List
A
◆ o: Operator Related Parameters
o parameters are used to set up the LED digital operator displays.
No. Name Description Range Def.
Control
Mode
Addr.
Hex
Pg.
V/f
O
LV
P
M
o1: Display Settings
Use o1 parameters to configure the digital operator display.
o1-01
<22>
Drive Mode Unit
Monitor Selection
Selects which monitor will be displayed in the
operation menu upon power-up when o1-02 =
5. The monitor parameter number is entered
into the spaces provided: U-. For
example, set “403” to display monitor
parameter U4-03.
104 to
621
106 A A A 500
234
Set to U1-06 as a default
(Output Voltage Reference).
o1-02
<22>
User Monitor
Selection After Power
Up
Selects the monitor to display upon power-up.
1: Frequency Reference (U1-01)
2: Forward/Reverse
3: Output Frequency (U1-02)
4: Output Current (U1-03)
5: User Monitor (set by o1-01)
1 to 5 1 A A A 501 234
o1-03
Digital Operator
Display Selection
Sets the units to display the frequency reference
and output frequency.
0: Hz
1: % (100% = E1-04)
2: r/min (enter the number of motor poles into
E2-04/E4-04/E5-04)
3: User defined by parameters o1-10 and o1-11
0 to 3 0 A A A 502 234
o1-10
Frequency Reference
Setting and User-Set
Display
These settings define the display values when
o1-03 is set to 3.
o1-10 sets display values when operating at the
maximum output frequency.
o1-11 sets the position of the decimal positions.
1 to
60000
<11> A A A 520 235
o1-11
Frequency Reference
Setting / Decimal
Display
0 to 3
<11> A A A 521 235
o2: Operator Keypad Functions
Use o2 parameters to configure LED digital operator key functions.
o2-01
LO/RE Key Function
Selection
Enables/Disables the digital operator LO/RE
key.
0: Disabled
1: Enabled
0,1 1 A A A 505 236