2.11 Communication Errors
292 YASKAWA ELECTRIC SIEP C710606 10A YASKAWA AC Drive - V1000 PRELIM. Programming Manual
• When the slave address in the command message and the slave address in the drive do not
match (remember to set the slave address for the drive using H5-01).
• When the gap between two blocks (8 bit) of a message exceeds 24 bits.
• When the command message data length is invalid.
Note: If the slave address specified in the command message is 00H, all slaves execute the write
function, but do not return response messages to the master.
To Next Page
Loading...
