1.2 b: Application
46 YASKAWA ELECTRIC SIEP C710606 10A YASKAWA AC Drive - V1000 PRELIM. Programming Manual
Setting 0: Disabled
A Run command is not accepted while the digital operator is in Programming Mode.
Setting 1: Enabled
A Run command is accepted in any digital operator mode.
Setting 2: Prohibit Programming During Run
It is not possible to enter the Programming Mode as long as the drive output is active.
■ b1-14: Phase Order Selection
Sets the phase order for drive output terminals U/T1, V/T2, and W/T3.
Setting 0: Standard Phase Order
Setting 1: Switched Phase Order
■
b1-15: Frequency Reference Selection 2
Refer to the detailed description for parameter b1-01.
■ b1-16: Run Command Source 2
Refer to the detailed description for parameter b1-02.
■ b1-17: Run Command at Power Up
This parameter is used to determine whether an external Run command that is active during
power up of the drive will start the drive or not.
No. Parameter Name Setting Range Default
b1-08
Run Command Selection while in Programming
Mode
0 to 2 0
No. Parameter Name Setting Range Default
b1-14 Phase Order Selection 0 or 1 0
No. Parameter Name Setting Range Default
b1-15 Frequency Reference 2 0 to 4 0
No. Parameter Name Setting Range Default
b1-16 Run Command Source 2 0 to 3 0
To Next Page
Loading...
