Yealink SIP-T38G

Appendix
267
Parameter-
account.x.dialoginfo_callpickup
Configuration File
<MAC>.cfg
Description
Configures the Dialog-Info Call Pickup feature
for account X.
If set to 1 (Enabled), call pickup is
implemented through SIP signals.
X ranges from 1 to 6.
Format
Boolean
Default Value
0
Range
0-Disabled
1-Enabled
Example
account.1.dialoginfo_callpickup = 1
Parameter-
network.web_server_type
Configuration File
<y0000000000xx>.cfg
Description
Specifies the access type of the web user
interface of the IP phone.
If set to 0 (Disabled), you are not allowed to
access the web user interface of the IP
phone.
If set to 1 (HTTP & HTTPS), you can access the
web user interface of the IP phone using HTTP
protocol or HHTPS protocol.
If set to 2 (HTTP Only), you can access the
web user interface of the IP phone using HTTP
protocol only.
If set to 3 (HTTPS Only), you can access the
web user interface of the IP phone using
HTTPS protocol only.
Note: If you change this parameter, the IP
phone will reboot to make the change take
effect.
Format
Integer