Configuring Basic Features
111
4. Select the desired type from the pull-down list of Type.
5. Click Confirm to accept the change.
The web user interface pops up a dialog box to prompt that the settings will take
effect after reboot.
6. Click OK to reboot the IP phone.
To configure the web server type via phone user interface:
1. Press Menu->Settings->Advanced Settings (password: admin)
->Network->Webserver Type.
2. Press or , or the Switch soft key to select the desired type from the
Webserver Type field.
3. Press the Save soft key to accept the change.
The IP phone reboots automatically to make the settings effective after a period of
time.
Calling Line Identification Presentation (CLIP) allows the IP phone to display the caller’s
identity, derived from a SIP header contained in the INVITE message, when receiving an
incoming call. The IP phones support three types of SIP headers: From,
P-Asserted-Identity and Remote-Party-ID. Identity presentation is based on the identity in
the relevant SIP header.
If the caller has existed in the local directory, the local name assigned to the caller
To Next Page
Loading...
