Getting Started
19
To configure DHCP via phone user interface:
1. Press Menu->Settings->Advanced Settings (password: admin) ->Network->WAN
Port.
2. Press or to highlight the DHCP IP Client field, and then press the Enter soft
key.
The IP phone reboots automatically to make the settings effective after a period of
time.
If DHCP is disabled or the IP phones cannot obtain network parameters, you need to
manually configure them. The following parameters should be configured for the IP
phones to establish network connectivity:
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
Procedure
Network parameters can be configured manually using the configuration files or
locally.
Configure network parameters of
the IP phone manually.
For more information, refer to
Static Network Settings on page
225.
Configure network parameters of
the IP phone manually.
Navigate to:
http://<phoneIPAddress>/cgi-bin/
cgiServer.exx?page=Network-B
asic.htm
Configure network parameters of
the IP phone manually.
To configure network parameters manually via web user interface:
1. Click on Network->Basic.
2. In the Internet Port field, mark the Static IP Address radio box.