YOKOGAWA FC400G

< 5. Key Operation and Display >
5-6
IM 12F5A1-01E
5.3.5 TransfertotheServiceLevel
Press the
＊
key to select the setting level from measurement mode.
Nextpressthe
NO
key to call “ *SERVC ” and press the
YES
key to enter the service level. Then
enter a code.
To return from the service level to the measurement mode in the operation level, press the
MODE
key.
However,iftheFC400Gisintheholdstatus,transfertothemeasurementmodeisdisabledandthe
FC400Greturnstothe<HOLD>mode.
(Example)
YES NO
HOLD
MEASURE
OUTPUT
MODE
NO
HOLD
F5.3.5e.ai
SERVICE
YES NO
∗
∗
∗
∗
MODE
ENT
YES NO
NO
YES
ENT
x 3
SERVICE
MODE
(Not in
hold status)
(In hold status)
is available.
(In hold status)
is not available.
( Display changes depend on CODE )
is not available.