<4. Setting converter>
4-23
IM 12A01G01-03EN 1st Edition : Mar. 25, 2021-00
4.9 Logbook settings
Logbook of FLXA402T records history of events such as setting change, calibration, alarm on/o,
and others. Logbook helps you, for example, to be aware of maintenance due.
Data in Logbook cannot be deleted, once it is stored.
Congure Logbook setting, by selecting “On” or “O” to each displayed item. (Default are all
“O”.)
Once you store data, the data are sorted out, being categorized into Converter and sensors.
Alarm name Description
System Error on Converter error occurs.
Error o Converter error is cancelled
mA output setup mA output settings are changed
wash setting Wash setup is changed.
Relay alarm setup Contact output alarm setup is changed.
Relay function setup Contact output function setup is changed.
Relay fail setup Contact output error setup is changed.
Relay simulate setup Contact output simulate setup is changed.
Sensor Error on Sensor error occurs.
Error o Sensor error is cancelled.
Compensation setup Compensation setup is chaged.
Calibration setup Calibration setup is changed.
Impedance setup Impedance setup is changed.
Refer to 4.8 Error settings. When you set “Error settings” to “O”, the alarm does not come
to display, but the converter detects errors inside. You can see the error history recorded in the
logbook, by setting “Logbook settings” to “Error On”.
NOTE
Sensors record logbooks of alarm message or event history such as calibration.
The converter shows only the history of events that took place after the corresponding sensor
was connected to the converter.
NOTE
When the storage of Logbook is full, the old data gets deleted rst
To Next Page
Loading...
Need help?
General
