YOKOGAWA YS1000 Series User Manual

39
IM 01B08B02-01EN
Operating the Engineering
Displays
Operating the Engineering Displays
Registering a Tag and Units
Setting Display
Engineering Display
0705E.ai
Operation Display >
SHIFT
+ keys (to the Tuning Menu Display) >
SHIFT
+ keys (to
the Engineering Menu Display) > [CONFIG2] software key (Configuration Display 2)
Setpoint changing procedure (example of setting a tag):
(1) Pressthe[↓]softwarekeytoselectandzoominon[SETINHB].
(2) Press the [ ] software key to change to [SET ENBL].
(3) Pressthe[↓]softwarekeytoselectandzoominontagnumber1[TAG1---YS1700---].
(4) Pressthe[↓]or[↑]softwarekeytomovethecursoroverthepositionwherethetagis
registered.
(5) Press the [ ] or [ ] software key to change the character (setting is made on a
character basis).
(6) Repeat steps (4) and (5) to register the tag.
(To erase a character, enter a space.)
(7) Press the Page key to return to the Engineering Menu Display.
(8) Press the SHIFT + Page keys to return to the Operation Display.
This completes the setting procedure.
Setting Details
Parameters Names Setting Range Factory Default
TAG1, TAG2 Tag number 12 digits of alphanumeric characters
For YS1700: ---YS1700---
For YS1500: ---YS1500---
UNIT1, UNIT2 Engineering units 7 digits of alphanumeric characters %
Description
The TAG2 and UNIT2 parameters are used in the loop 2 in the cascade mode, selector mode, and programmable mode.
The tag is displayed in the top line of the LCD.
The settable ASCII codes are as shown below:
Space ! “ # $ % & ’ ( ) * + , -
. / 0 1 2 3 4 5 6 7 9 : ; < =
> ? @ A B C D E F G H I J K L
M N O P Q R S T U V W X Y Z [
¥ ] ^ _ ` a b c d e f g h i j
k l m n o p q r s t u v w x y
z { ¦ } ~

YOKOGAWA YS1000 Series Specifications

General

Brand	YOKOGAWA
Model	YS1000 Series
Category	Controller
Language	English