64
IM 01B08B02-01EN
64
List of Parameters
Understanding the List of Parameters
Parameter: Symbol displayed on YS1000’s LCD
Name: Parameter name
Setting and Display Range: Range settable on YS1000
Unit: Parameter unit. An oblique line represents that there is no unit.
Factory Default Value: Factory default values for YS1500 (single-loop mode) and YS1700 (programmable mode)
Values in parentheses indicate the initial value applied when the controller mode is changed.
Display and Setting Conditions for Controller Mode: R: Display only, R/W: Display and setting available, N/A: No display
Description of symbols:
SINGLE: Single-loop mode
CAS: Cascade mode
SELECT: Selector mode
PROG: Programmable mode (YS1700 only)
For more information about each parameter, see the YS1500 Indicating Controller/ YS1700 Programmable Indicating Controller
User’s Manual.
Note
Parameters are initialized if the controller mode selection (CTL) parameter is changed:
All parameters will be initialized with the exception of setpoint 1 (SV1), setpoint 2 (SV2), user program name (PROG), system
Rev. No. (REV), password, all parameters on the LCD Setting Display, and all parameters on the Communication Setting
Display.
To Next Page
Loading...
Need help?
General
