37
14. Touch [Close] when all batches are created.
15. To save your plate configurations to a flash drive, touch [Export].
16. Select the plates you want to export, and then touch [Export].
17. Previously exported plates can be imported later using the [Import] button.
5.3.2 Load Samples
5.3.2.1 R24 and P6-P96 Racks/Plates
1. Open the front door of the instrument
2. Insert the plate/rack (end marked A1 first) into the instrument. Slide the front edge of the plate/rack in until it
stops.
Figure 5.1
3. Gently lower the rear of the plate/rack and push it down into position.
To Next Page
Loading...
