68
7. System Configuration
Settings 7.1
Touch [Settings] to display the global settings screen as shown below. Settings include System, Display, and Scheduler.
NOTE: If 21 CFR Part 11 mode is enabled, only an Administrator can access Settings.
7.1.1 System
Touch the [System] tab (if not already selected). The System tab is used to select the type of sample and calibration
reports, enable sipper fluid detection, and print the configuration.
7.1.1.1 Report Details
To change the Sample or Calibration Reports, touch the button below it to cycle through the selections—Detailed, Brief, or
None.
To Next Page
Loading...
