69
7.1.1.2 Communication Port
Set the Communications Port to [Printer] when using the optional YSI 2901 Printer.
The RS232 Communications Port can also be used to connect the 2900 Series to a remote host. Set the Communications
Port to [Remote Commands] to enable the remote host to send commands to the 2900 Series.
7.1.1.3 Print Configuration
Touch the [Print Configuration] button to send the current instrument configuration to the printer.
7.1.1.4 Sipper options
Touch the Sensitivity [High] button and change it to [Low] for samples with high conductivity.
Touch the Fluid Detector [On] button and change it to [Off] to completely disable sipper fluid detection at all locations,
including the calibrator wells.
To Next Page
Loading...
