82
Service 7.2
Touch [Service] to display the Service menu.
7.2.1 Sipper
See Section 4.5 Align Sipper for details on aligning the sipper with each sample module.
If necessary, the sipper can also be aligned with Station 2, the different types of racks/plates used at Station 1, and the
calibrator wells.
NOTE: If 21 CFR Part 11 mode is enabled, only an Administrator can access the Sipper tab.
7.2.1.1 Interlock
Touch the Interlock button and change the status to [Off] to disable the interlock switches on the front door and side panel
when aligning the sipper.
WARNING: Keep your hands clear of the sipper while the instrument is in operation.
Always turn the Interlock back [On] before operating the instrument!
To Next Page
Loading...
