Zebra TC70x - DataWedge Configuration

Data Capture 5 - 13
5. Touch Bluetooth.
6. Touch SCAN FOR DEVICES. The TC70x/TC75x begins searching for discoverable Bluetooth devices in the
area and displays them under Available devices.
7. Scroll through the list and select DS3678 xxxxxx, where xxxxxx is the serial number.
The TC70x/TC75x connects to the DS3678, the DS3678 beeps once and Connected appears below the
device name. The Bluetooth device is added to the Bluetooth devices list and a trusted (“paired”) connection
is established.
DataWedge
DataWedge is a utility that adds advanced bar code scanning capability to any application without writing code. It
runs in the background and handles the interface to built-in bar code scanners. The captured bar code data is
converted to keystrokes and sent to the target application as if it was typed on the keypad.
To configure DataWedge refer to the TC70x/TC75x Integrator Guide for Android Version 6.0.1.
Enabling DataWedge
1. Touch > .
2. Touch > Settings.
3. Touch the DataWedge enabled checkbox. A blue checkmark appears in the checkbox indicating that
DataWedge is enabled.
4. Touch .
Disabling DataWedge
1. Touch > .
2. Touch > Settings.
3. Touch the DataWedge enabled checkbox. The blue checkmark disappears from the checkbox indicating that
DataWedge is disabled.
4. Touch .