SpeedFace-V5L Series User Manual
Page | 58 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
Periodic Del of ATT
Photo
When attendance photos reach its maximum capacity, the device
automatically deletes a set of old attendance photos.
Users may disable the function or set a valid value between 1 and 99.
Periodic Del of
Blocklist Photo
When block listed photos reach its maximum capacity, the device
automatically deletes a set of old block listed photos.
Users may disable the function or set a valid value between 1 and 99.
Authentication
Timeout (s)
The amount of time taken to display a successful verification message.
Valid value: 1~9 seconds.
Face Comparison
Interval (s)
The amount of time required to compare facial templates.
Valid value: 0~9 seconds.
Face Parameters
Tap Face on the System interface to go to the face parameter settings.
Function Description
Function Name Description
1:N Match Threshold
Under 1:N verification mode, the verification will only be successful when the
similarity between the acquired facial image and all registered facial templates
is greater than the set value.
The valid value ranges from 65 to 120. The higher the thresholds, the lower the
misjudgement rate and the higher the rejection rate, and vice versa. It is
recommended to set the default value of 75.
To Next Page
Loading...
Need help?
General
