SpeedFace-V5L Series User Manual
Page | 61 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
Function Description
Function Name Descriptions
1:1 Match
Threshold
Under 1:1 verification method, the verification will only be successful when the
similarity between the acquired fingerprint data and the fingerprint template
associated with the entered user ID enrolled in the device is greater than the set
value.
1:N Match
Threshold
Under 1:N verification method, the verification will only be successful when the
similarity between the acquired fingerprint data and the fingerprint templates
enrolled in the device is greater than the set value.
FP Sensor
Sensitivity
To set the sensibility of fingerprint acquisition. It is recommended to use the
default level "Medium". When the environment is dry, resulting in slow fingerprint
detection, you can set the level to "High" to raise the sensibility; when the
environment is humid, making it hard to identify the fingerprint, you can set the
level to "Low".
1:1 Retry Times
In 1:1 Verification, users might forget the registered fingerprint, or press the finger
improperly. To reduce the process of re-entering user ID, retry is allowed.
Fingerprint Image
This function is disabled by default. After disabling it, the fingerprint image will
not be displayed when registering and verifying fingerprints. The menu interface
allows to enable or disable this function, and there are security prompts when
switching. Four choices are available:
Show for enroll
: to display the fingerprint image on the screen only during
enrollment.
Show for match
: to display the fingerprint image on the screen only during
verification.
Always show: to display the fingerprint image on screen during enrollment and
verification.
None: not to display the fingerprint image.
Video Intercom Parameters
Click Video intercom parameters on the System interface.
To Next Page
Loading...
Need help?
General
