Name: ZKTeco SpeedFace-V5L Series
Brand: ZKTeco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

SpeedFace-V5L Series User Manual

Duress Options Settings

Once a user activates the duress verification function with a specific authentication method(s), and when

he/she is under coercion and authenticates using duress verification, the device unlocks the door as usual.

At the same time, a signal is sent to trigger the alarm as well.

On the Access Control interface, tap Duress Options to configure the duress settings.

Function Description

Function Name Description

Alarm on Password

When a user uses the password verification method, an alarm signal will be

generated, otherwise there will be no alarm signal.

Alarm on 1:1 Match

When a user uses the 1:1 verification method, an alarm signal will be generated,

otherwise there will be no alarm signal.

Alarm on 1:N Match

When a user uses the 1:N

verification method, an alarm signal will be

generated, otherwise there will be no alarm signal.

Alarm Delay (s)

Alarm signal will not be transmitted until the alarm delay time is elapsed. The

value ranges from 1 to 999 seconds.

Duress Password

Set the 6-digit duress password. When the user enters this duress password for

verification, an alarm signal will be generated.

Other manuals for ZKTeco SpeedFace-V5L Series

Questions and Answers:

Need help?

Do you have a question about the ZKTeco SpeedFace-V5L Series and is the answer not in the manual?

General