SpeedFace-V5L Series User Manual
Page | 23 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
2.6.3 Facial Verification
1:N Facial Verification
Conventional
Verification
In this verification mode, the device compares the collected facial images with all face data registered in
the device. The following is the pop-up prompt of a successful comparison result.
Enable Temperature Screening with Infrared
When the user enables the Enable temperature screening with infrared function, during user
verification, in addition to the conventional verification method, the user's face must be aligned with the
temperature measurement area to measure the body temperature before the verification can be
conducted. The following are the popups of the comparison result prompt interface. (Note: This function is
only applicable to products with temperature measurement module.)
To Next Page
Loading...
