SpeedFace-V5L Series User Manual
Page | 24 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
Enable Mask Detection
When the user enables the Enable mask detection function, the device will identify whether the user is
wearing a mask or not while verification. The following are the popups of the comparison result prompt
interface. (Note: This function is only applicable to products with temperature measurement module.)
Display Thermodynamics Figure
When the user enables the Display Thermodynamics Figure function, the thermal image of the person is
displayed in the upper left corner of the device, while verification. As shown in the images below:
To Next Page
Loading...
