SpeedFace-V5L Series User Manual
Page | 63 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
Standalone
Communication
By default, this function is disabled. This function can be enabled or disabled via
the menu interface. When it is switched on, a security prompt appears, and the
device will restart after you confirm.
SSH
The device does not support the Telnet feature, hence SSH is typically used for
remote debugging. By default, SSH is enabled. The menu interface allows you to
enable and disable SSH. When enabled, there will be a security prompt, but the
device will not need to be restarted after confirmation.
User ID Masking
After enabled, the Use
r ID will be partially displayed after the personnel
verification result (only the User ID with more than 2 digits supports the masking
display), and it is enabled by default.
Display
Verification Name
After enabled, the user's name will be displayed after the personnel verification
result. The verification result will not show the name after disabling it.
Display
Verification Mode
After enabled, the personnel verification result will show the user's verification
mode. The verification result will not
show the verification mode after you
disable it.
Factory Reset
The Factory Reset function restores the device settings such as communication settings and system
settings, to the default factory settings (this function does not clear registered user data).
Tap Reset on the System interface and then tap OK to restore the default factory settings.
To Next Page
Loading...
Need help?
General
