SpeedFace-V5L Series User Manual
Page | 65 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
Temperature
Measurement
Distance
When measuring temperature during the verification process, there are three
modes: Near, Close and Far.
Display
Thermodynamics
Figure
To enable or disable the display of the thermal image of a person.
When enabled, the thermal image of the person is be displayed in the upper
left corner of the device during the detection process.
Enable Palm Temp.
Detection
To enable or disable the palm temperature detection function.
When enabled, the device will display the user's palm temperature during the
verification process.
Note:
This function is not enabled by default, and can be upgraded to
support.
Temperature
Calibration
Calibrate the temperature by comparing the current temperature value with
the surface temperature value of the device.
Enable Mask
Detection
To enable or disable the mask detection function.
When it’s enabled, the device will identify whether the user is wearing a mask
or not during verification.
Display Body
Temperature
To enable or disable the display body temperature function.
When enabled, the device will display the user's specific temperature value
during the verification process.
Enable Mask
Detection
To enable or disable the mask detection function.
When it’s enabled, the device will identify whether the user is wearing a mask
or not during verification.
Deny Access without
Mask
To enable or disable the deny access without mask function.
When it’s enabled, even if the body temperature is normal, the person who
does not wear a mask will not allow the person to enter.
Allow Unregistered
People to Access
To enable or disable the unregistered people to access function.
When enabled, as long as the person who passes the detection, the device
allows the personnel to enter without registration.
Enable Capture of
Unregistered Person
To enable or disable the capture of unregistered person function.
When enabled, the device will automatically capture the photo of the
unregistered person, enabling this feature requires to enable Allow
Unregistered People to Access.
Trigger External
Alarm
When enabled, if the user's temperature is higher than the set threshold value
or the mask detection is enabled, but the mask is not worn by the person, it
will trigger an alarm.
Clear External Alarm
It clears the triggered alarm records of the device.
External Alarm
Delay(s)
The delay (s) time for triggering an external alarm. It can be set in seconds.
Users may disable the function or set a value between 1 to 255.
To Next Page
Loading...
Need help?
General
