Making input settings
Selecting inputs for making settings
Input settings can be made for each input separately. Select the input desired for making input settings.
1. Press for the input desired for making settings.
• : Open the settings screen for Input 1.
• : Open the settings screen for Input 2.
NOTE:
On each Input Settings Screen, only sound from that input can be monitored (only the signal output from
the PHONE OUT jack).
The following parameters can be set for each input.
Item Explanation
On/Off This turns the input on or off. (→ Turning inputs on/off)
Source
This sets the input source and phantom power on/off status of the
track. (→ Setting input sources)
Phantom Volt.
The voltage of the phantom power can be changed. (→ Changing
phantom power voltage)
HPF
The high pass filter can cut low frequencies to reduce the sound of
wind, vocal pops and other noise. (→ Reducing noise (low-frequency
cut))
Invert Phase
The phase of input signals can be inverted. This is useful when
sounds cancel each other out due to mic settings. (→ Inverting input
phase)
Delay
If there are differences in the timing of input sounds, use this
function to correct them when recording. (→ Applying delay to input
signals)
31
To Next Page
Loading...
Need help?
General
Weight and Dimensions
