Zoom F3 - Applying Delay to Input Signals

Applying delay to input signals
If there are differences in the timing of input signal sounds, use this function to correct them when
recording.
1. Press for the input to set. (→ Selecting inputs for making settings)
This opens the Input Settings Screen.
2. Use / to select “Delay” and press to confirm.
3. Use / to set the delay time and press to confirm.
NOTE:
If the sample rate is 192 kHz, delay will be disabled. (→ Setting the sample rate)
HINT:
This can be set from 0.0 ms to 30.0 ms.
38