Recording
Waveforms shown when recording
The F3 records in 32-bit float format, so the input gain does not need to be adjusted. Depending on the
input signals, however, waveforms shown on the display could appear too small or too large, making them
difficult to check.
By changing the waveform display magnification, input waveforms can be adjusted to sizes that are easy to
check. The magnification rate can be set separately for each input.
The volume will also be changed according to the waveform magnification rate.
1. Press for the input desired for making settings.
• : Use this to set Input 1.
• : Use this to set Input 2.
Icons to decrease/increase ( / ) the magnification for that input will appear.
45
To Next Page
Loading...
