4. Tap “Quick Test” or “Full Test”. Then, tap “Execute”.
The card performance test will start.
Quick testing Full testing
The Quick Test should take about 30 seconds. The amount of time required for the full test will
be shown.
The result of the test will be shown when it completes.
During a full test, if the access rate MAX reaches
100％,
the card will fail (NG).
NOTE:
Even if a performance test result is "OK", there is no guarantee that writing errors will not occur. This
information is just to provide guidance.
HINT:
Tap to cancel a test.
181
To Next Page
Loading...
