Setting tracks for output as MASTER and CLICK signals.
Set the output destination of each track.
By setting rhythm tracks, for example, to CLICK, they can be used like a click during recording, synchronized
performances and other situations.
1. Tap the Output Routing □ boxes on the Project Settings Screen (→ Opening the screen where various
project settings can be made).
Set the output destination for each track to MASTER or CLICK.
• MASTER: The sound is output from both the OUTPUT and PHONES jacks.
• CLICK: The sound is output only from the PHONES jack, and the volume balance between the
MASTER and CLICK output signals can be adjusted.
NOTE:
Set to PHONES to output the CLICK signal from the PHONES jack, and use to adjust the
volume balance with the MASTER output.
47
To Next Page
Loading...
Need help?
General
