Contents
3
Contents
1 About these instructions.................................................................................................................5
1.1 Scope................................................................................................................................................5
1.2 Presentation conventions..................................................................................................................5
1.3 Legal notice...................................................................................................................................... 5
1.4 Other applicable documents.............................................................................................................5
1.5 Service contact................................................................................................................................. 6
2 Safety.................................................................................................................................................7
2.1 Basic safety...................................................................................................................................... 7
2.2 Personal protective equipment.........................................................................................................8
2.3 Requirements for personnel and third parties..................................................................................8
3 Tools, operating and auxiliary materials....................................................................................... 9
3.1 Tools................................................................................................................................................. 9
3.2 Operating materials.......................................................................................................................... 9
4 Setting up........................................................................................................................................11
4.1 Overview......................................................................................................................................... 11
4.2 Turn off the cutter...........................................................................................................................11
5 Setting up the control panel/workstation.................................................................................... 13
5.1 Dismantling the existing control panel/workstation.........................................................................13
5.2 Connect cable to the cutter............................................................................................................19
5.3 Positioning the control panel / workstation.....................................................................................20
5.4 Assembly with segment anchors (fastening to the floor)............................................................... 22
5.5 Installation with auxiliary bracket....................................................................................................24
5.6 Connecting the cable to the operating unit....................................................................................25
5.7 Connecting the earthing and power supply for the control panel/workstation................................ 26
5.8 Connect the PC connections..........................................................................................................27
5.9 Mounting the PC cover...................................................................................................................28
5.10 Mount the trip protection.............................................................................................................. 29
6 Installing the S-box........................................................................................................................31
6.1 Preparing to fasten the S-box........................................................................................................ 31
6.2 Installing the S-box.........................................................................................................................32
6.3 Mounting the Varioface module on the G3/D3 cutter (system A)...................................................33
6.4 Connect S-box................................................................................................................................34
7 Cutter without material transport.................................................................................................37
7.1 Mounting the rear access guard.................................................................................................... 37
7.2 Fastening the pillars to the floor (with segment anchors).............................................................. 39
7.3 Mounting the pillars onto the auxiliary brackets.............................................................................46
8 Cutter with material transport and CE.........................................................................................51
8.1 Mounting the rear access guard.................................................................................................... 51
8.2 Mounting the material hold-down roll............................................................................................. 54
To Next Page
Loading...
