Cutter with material transport and CE
56
8.3 Fastening the pillars to the floor (with segment anchors)
Caution:
Incorrect set-up of the pillars can lead to accidents
The distances of the pillars to the cutter must be strictly observed.
• Check the positions of the marked drill holes using the reference dimension (see imprint on the
drilling templates orDiagrams on page 99).
The drilling templates are included in the delivery scope. These are used to mark the drill holes on the
feet of the cutter.
The number and labeling indicate the cutter size and side to which the drilling template applies.
The printed line that goes all the way through facilitates the right-angled alignment to the cutter covers
and the longitudinal pipe of the cutter extension.
To Next Page
Loading...
