Setting up the light curtain
84
10.2.6 Fine adjustment
Tip:
The pillar can be slightly tilted by hand. This makes it easier to determine the required adjustment.
The pillar with mirror is present depending on the cutter size.
1 Light barrier transmitter/receiver
2 Clamping screw
A Tilt the pillar slightly to the left until the light barrier is interrupted.
• On the receivers of both light curtain pairs, the red "Interruption" LED lights up.
• A low-volume switching noise of the relay can be heard in the S-box.
B Tilt the pillar slightly to the right until the light barrier is interrupted.
• On the receivers of both light curtain pairs, the red "Interruption" LED lights up.
• A low-volume switching noise of the relay can be heard in the S-box.
C Slightly loosen the clamping screws of the retaining brackets.
D Align the light barrier transmitter / receiver so that the deflection is even until switching to both
sides.
E Repeat the process on the other light barrier transmitter/receiver pair.
To Next Page
Loading...
