Chapter 85 Additional Commands
Ethernet Switch CLI Reference Guide
325
This example displays multicast VLAN configuration on the Switch.
The following table describes the labels in this screen.
This example shows the current status of Power over Ethernet.
The following table describes the labels in this screen.
Current This field displays the current voltage at this power supply.
Max This field displays the maximum voltage measured at this power supply.
Min This field displays the minimum voltage measured at this power supply.
Threshold This field displays the percentage tolerance within which the Switch still
works.
Status Normal: The current voltage is within tolerance.
Error: The current voltage is outside tolerance.
sysname> show multicast vlan
Multicast Vlan Status
Index VID Type
----- ---- ----------
1 123 MVR
Table 186 show multicast vlan
LABEL DESCRIPTION
Index This field displays an entry number for the multicast VLAN.
VID This field displays the multicast VLAN ID.
Type This field displays what type of multicast VLAN this is.
MVR: This VLAN is a Multicast VLAN Registration (MVR).
Static: This VLAN is configured via IGMP snooping VLAN in fixed mode.
Dynamic: This VLAN is learned dynamically in auto mode.
See Chapter 27 on page 115 for more information about IGMP snooping
VLAN and IGMP modes.
sysname# show poe-status
Total Power (W) : 185.0
Consuming Power (W) : 0.0
Allocated Power (W) : 0.0
Remaining Power (W) : 185.0
Table 187 show poe-status
LABEL DESCRIPTION
Total Power This field displays the total power the Switch can provide to PoE-enabled
devices.
Consuming Power This field displays the amount of power the Switch is currently supplying to
the PoE-enabled devices.
Table 185 show hardware-monitor (continued)
LABEL DESCRIPTION
To Next Page
Loading...
Need help?
General
