Chapter 85 Additional Commands
Ethernet Switch CLI Reference Guide
326
This example looks at general system information about the Switch
The following table describes the labels in this screen.
Allocated Power This field displays the total amount of power the Switch has reserved for
PoE after negotiating with the PoE device(s).
Note: If the management mode is set to Consumption, this
field shows NA.
Remaining Power This field displays the amount of power the Switch can still provide for PoE.
Note: The Switch must have at least 16 W of remaining power
in order to supply power to a PoE device, even if the
PoE device requested less than 16 W.
sysname# show system-information
Product Model : XGS-4728F
System Name : XGS-4728F
System Contact :
System Location :
System up Time : 0:06:21 (9511 ticks)
Ethernet Address : 00:19:cb:6f:91:59
Bootbase Version : V1.00 | 10/22/2007
ZyNOS F/W Version : V4.00(BBC.0)b1 | 10/14/2010
RomRasSize : 4069634
Table 188 show system-information
LABEL DESCRIPTION
Product Model This field displays the model name.
System Name This field displays the system name (or hostname) of the Switch.
System Contact This field displays the name of the person in charge of this Switch. Use the
snmp-server command to configure this. See Chapter 67 on page 263.
System Location This field displays the geographic location of this Switch. Use the snmp-
server command to configure this. See Chapter 67 on page 263.
System up Time This field displays how long the switch has been running since it last started
up.
Ethernet Address This field displays the MAC address of the Switch.
Bootbase Version This field displays the bootbase version the Switch is running.
ZyNOS F/W Version This field displays the firmware version the Switch is running.
RomRasSize This field displays how much ROM is used.
ZyNOS CODE This field displays the ZyNOS operating system version the Switch is using.
Table 187 show poe-status (continued)
LABEL DESCRIPTION
To Next Page
Loading...
Need help?
General
