ZyXEL Communications ZyWALL USG 100 Series - Configure a WAN Ethernet Interface

Chapter 7 Tutorials
ZyWALL USG 100/200 Series User’s Guide
116
• This example does not use the ext-wlan interface (for Ethernet-connected APs)
so you remove port P6 from the ext-wlan interface and add it to the dmz
interface instead.
Figure 60 Ethernet Interface, Port Roles, and Zone Configuration Example
7.1.1 Configure a WAN Ethernet Interface
You need to assign the ZyWALL’s wan1 interface a static IP address of 1.2.3.4.