Chapter 41 Addresses
ZyWALL USG 100/200 Series User’s Guide
740
41.3 Address Group Summary Screen
The Address Group screen provides a summary of all address groups. To access
this screen, click Configuration > Object > Address > Address Group. Click a
column’s heading cell to sort the table entries by that column’s criteria. Click the
heading cell again to reverse the sort order.
Figure 496 Configuration > Object > Address > Address Group
The following table describes the labels in this screen. See Section 41.3.1 on page
741 for more information as well.
Interface If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE
GATEWAY as the Address Type, use this field to select the interface of
the network that this address object represents.
OK Click OK to save your changes back to the ZyWALL.
Cancel Click Cancel to exit this screen without saving your changes.
Table 202 Configuration > Object > Address > Address > Edit (continued)
LABEL DESCRIPTION
Table 203 Configuration > Object > Address > Address Group
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The ZyWALL confirms
you want to remove it before doing so.
Object
References
Select an entry and click Object References to open a screen that
shows which settings use the entry. See Section 13.3.2 on page 306 for
an example.
# This field is a sequential value, and it is not associated with a specific
address group.
Name This field displays the name of each address group.
Description This field displays the description of each address group, if any.
To Next Page
Loading...
