Chapter 4 Installation Setup Wizard
ZyWALL USG 100/200 Series User’s Guide
66
4.1.3 Internet Access: PPPoE
Note: Enter the Internet access information exactly as given to you by your ISP.
Figure 30 Internet Access: PPPoE Encapsulation
4.1.3.1 ISP Parameters
• Type the PPPoE Service Name from your service provider. PPPoE uses a service
name to identify and reach the PPPoE server. You can use alphanumeric and -
_@$./ characters, and it can be up to 64 characters long.
• Authentication Type - Select an authentication protocol for outgoing
connection requests. Options are:
• CHAP/PAP - Your ZyWALL accepts either CHAP or PAP when requested by
the remote node.
• CHAP - Your ZyWALL accepts CHAP only.
• PAP - Your ZyWALL accepts PAP only.
• MSCHAP - Your ZyWALL accepts MSCHAP only.
• MSCHAP-V2 - Your ZyWALL accepts MSCHAP-V2 only.
• Type the User Name given to you by your ISP. You can use alphanumeric and -
_@$./ characters, and it can be up to 31 characters long.
• Type the Password associated with the user name. Use up to 64 ASCII
characters except the [] and ?. This field can be blank.
• Select Nailed-Up if you do not want the connection to time out. Otherwise,
type the Idle Timeout in seconds that elapses before the router automatically
disconnects from the PPPoE server.
To Next Page
Loading...
