ZyXEL Communications ZyWALL USG 100 Series - WAN and ISP Connection Settings

Chapter 5 Quick Setup
ZyWALL USG 100/200 Series User’s Guide
76
• IP Address Assignment: Select Auto If your ISP did not assign you a fixed IP
address.
Select Static If the ISP assigned a fixed IP address.
5.2.4 WAN and ISP Connection Settings
Use this screen to configure the ISP and WAN interface settings. This screen is
read-only if you set the IP Address Assignment to Static.
Note: Enter the Internet access information exactly as your ISP gave it to you.
Figure 41 WAN and ISP Connection Settings: (PPTP Shown)
The following table describes the labels in this screen.
Table 10 WAN and ISP Connection Settings
LABEL DESCRIPTION
ISP Parameter This section appears if the interface uses a PPPoE or PPTP Internet
connection.
Encapsulation This displays the type of Internet connection you are configuring.