Chapter 56 Troubleshooting
ZyWALL USG 100/200 Series User’s Guide
921
If you want to reboot the device without changing the current configuration, see
Chapter 54 on page 899.
1 Make sure the SYS LED is on and not blinking.
2 Press the RESET button and hold it until the SYS LED begins to blink. (This
usually takes about five seconds.)
3 Release the RESET button, and wait for the ZyWALL to restart.
You should be able to access the ZyWALL using the default settings.
56.2 Getting More Troubleshooting Help
Search for support information for your model at www.zyxel.com for more
troubleshooting suggestions.
To Next Page
Loading...
