ZyXEL Communications ZyWALL USG 100 Series - Configuring the Legacy Mode Screen

Chapter 39 Device HA
ZyWALL USG 100/200 Series User’s Guide
710
39.6 Configuring the Legacy Mode Screen
The Device HA Legacy Mode screen lets you configure general legacy mode HA
settings including link monitoring, configure the VRRP group and synchronize
backup ZyWALLs. To access this screen, click Configuration > Device HA >
Legacy Mode.
Figure 481 Configuration > Device HA > Legacy Mode
The following table describes the labels in this screen. See Table 191 on page 713
for more information as well.The Legacy Mode Add/Edit Screen
Table 190 Configuration > Device HA > Legacy Mode
LABEL DESCRIPTION
General Settings
Link Monitoring Enable link monitoring to have the master ZyWALL shut down all of its
VRRP interfaces if one of its VRRP interface links goes down. This way
the backup ZyWALL takes over all of the master ZyWALL’s functions.
Stop Cellular
& WLAN
interfaces
while one of
monitored
interface is
fault
Select this to have the master ZyWALL shut down any 3G or wireless
LAN interfaces if one of its VRRP interface links goes down. Clear this if
you still want users to be able to use the ZyWALL’s 3G connection or
wireless LAN even when a VRRP interface link goes down.
Monitored
Interface
Summary
Add Click this to create a new entry.
Edit Select an entry and click this to be able to modify it.