ZyXEL Communications ZyWALL USG 100 Series - L2 TP VPN Example; Chapter 8 L2 TP VPN Example; Configuring the Default L2 TP VPN Gateway Example

ZyWALL USG 100/200 Series User’s Guide
185
CHAPTER 8
L2TP VPN Example
Here is how to create a basic L2TP VPN tunnel.
8.1 L2TP VPN Example
This example uses the following settings in creating a basic L2TP VPN tunnel.
Figure 152 L2TP VPN Example
• The ZyWALL has a static IP address of 172.16.1.2 for the wan1 interface.
• The remote user has a dynamic public IP address and connects through the
Internet.
• You configure an IP address pool object named L2TP_POOL to assign the
remote users IP addresses from 192.168.10.10 to 192.168.10.20 for use in the
L2TP VPN tunnel.
• The VPN rule allows the remote user to access the LAN_SUBNET which covers
the 192.168.1.x subnet.
8.2 Configuring the Default L2TP VPN Gateway
Example
1 Click Configuration > VPN > Network > IPSec VPN > VPN Gateway to open
the screen that lists the VPN gateways. Double-click the
Default_L2TP_VPN_GW entry.
172.16.1.2
L2TP_POOL:
192.168.10.10~192.168.10.20
LAN_SUBNET: 192.168.1.x